NOTE:
Vehicles sold in Canada are equipped with a headlight
switch with an AUTO and ON detent but without an OFF
detent. Headlights will be deactivated when the head-
light switch is placed in the parking lights position. How-
ever, the Daytime Running Lights (DRLs) will be acti-
vated along with the front and rear marker lights. The
DRLs may be deactivated when the parking brake is
engaged.
To turn on the headlights, rotate the headlight switch
clockwise. When the headlight switch is on, the parking
lights, taillights, license plate light and instrument panel
lights are also turned on. To turn off the headlights,
rotate the headlight switch back to the O (off) position.
NOTE:
For vehicles sold in Canada, rotate the headlight switch
clockwise from the parking lights and instrument panel
lights position to the first detent to turn the headlight
switch to the AUTO position. Rotate to the second
detent to turn on headlights, parking lights, and instru-
ment panel lights operation.
MULTIFUNCTION LEVER
The multifunction lever is located on the left side of the
steering column.
DAYTIME RUNNING LIGHTS (DRLS)
— IF EQUIPPED
The Daytime Running Lights will turn on when the
engine is started and will remain on unless the head-
lamps are turned to the on position, the parking brake
is applied, or the ignition is placed in the OFF position.
NOTE:
•
For vehicles sold in Canada, the Daytime Running
Lights will automatically deactivate when the front
fog lights are turned on.
•
If allowed by law in the country in which the vehicle
was purchased, the Daytime Running Lights can be
turned on and off using the Uconnect system
page 95.
•
On some vehicles, the Daytime Running Lights may
deactivate, or reduce intensity, on one side of the
vehicle (when a turn signal is activated on that
side), or on both sides of the vehicle (when the haz-
ard warning lights are activated).
HIGH/LOW BEAM SWITCH
Push the multifunction lever toward the instrument
panel to switch the headlights to high beams. Pulling
the multifunction lever back will turn the low beams on.
AUTOMATIC HIGH BEAM HEADLAMP
CONTROL — IF EQUIPPED
The Automatic High Beam Headlamp Control system
provides increased forward lighting at night by automat-
ing high beam control through the use of a camera
mounted on the windshield.
This camera detects vehicle specific light and automati-
cally switches from high beams to low beams until the
approaching vehicle is out of view.
NOTE:
•
The Automatic High Beam Headlamp Control can be
turned on or off using the Uconnect system
page 95.
•
Broken, muddy, or obstructed headlights and tail-
lights of vehicles in the field of view will cause head-
lights to remain on longer (closer to the vehicle).
Also, dirt, film, and other obstructions on the wind-
shield or camera lens will cause the system to func-
tion improperly.
•
If the windshield or Automatic High Beam Headlamp
Control mirror is replaced, the mirror must be
re-aimed to ensure proper performance. See a local
authorized dealer.
FLASH-TO-PASS
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the high beam headlights to turn on, and
remain on, until the lever is released.
NOTE:
If the multifunction lever is held in the flash-to pass
position for more than 20 seconds, the high beams will
shut off.
AUTOMATIC HEADLIGHTS
This system automatically turns the headlights on or off
according to ambient light levels. To turn the system on,
rotate the headlight switch counterclockwise to the
AUTO position.
Multifunction Lever
GETTING TO KNOW YOUR VEHICLE 37
2
5548538-23_LA_OM_EN_USC_t_E2.pdf 37 4/7/2023 2:38:35 PM
To Next Page
Loading...
