Voice Texting (U.S. Residents Only) — Want to dictate a personal message? Register with
Uconnect® Access to take advantage of a new, cloudbased Voice Texting service, an
enhancement to Voice Text Reply.
Voice Texting allows you to compose a new text or reply to an incoming text message.
Beforeyou attempt to use the Voice Texting feature, check to ensure you have the following:
1.
A paired, Bluetooth® enabled phone with the Message Access Profile (MAP). Not all Bluetooth®
enabled phones support MAP, including all iPhones® (Apple iOS). Visit UconnectPhone.com for
system and device compatibility information.
2.
An active Uconnect® Access trial or paid subscription. Press the “U” button on the lower
right hand corner of the touchscreen to begin the registration process.
3.
Accept the Allow MAP profile request on your smart phone. (Please refer to device manu-
facturer instructions for details).
To Send A Text Message:
1. Press the “Uconnect® Phone” button.
2. Wait for the beep.
3. Say “Text.”
4. Uconnect® will prompt you “Say the phone number, or full name and phone type of the
contact you want to send a message to.”
5. Wait for the beep and say a contact that is in your phonebook, or a mobile phone number
that you would like to send the message to.
6. Uconnect® will prompt you “Please say the message that you would like to send.” (If you
do not hear this prompt, you may not have an active subscription with Uconnect®
Access).
7. Wait for the beep, and then dictate any message up to 140 characters. If you exceed 140
characters, you will hear the following prompt: “Message was too long; your message will
be truncated.”
8. Uconnect® will then repeat the message back to you.
9.
Uconnect® will prompt you: “To add to your message, say “Continue”; To delete the current
message and start over, say “Start Over”; to send the current message, say “Send”; to hear
the message again, say “Repeat”.
10.
If you are happy with your message and would like to send it, wait for the beep and say
“Send”.
11. Uconnect® will then say “Sending your message.”
ELECTRONICS
61
To Next Page
Loading...
