Voice Text Reply (Not Compatible With iPhone)
NOTE:
V oice texting reply and voice texting features require a compatible mobile device enabled
with Bluetooth Message Access Profile (MAP). iPhone, and some other smartphones, may
not entirely support Bluetooth MAP. Visit UconnectPhone.com for the latest system and
device compatibility .
• Due to the extremely large number of mobile phone manufacturers, your mobile device
may not be listed. For further assistance, contact Uconnect Customer Care @
1-877-855-8400 for U.S. residents or , 1-800-465-2001 (English) /
1-800-387-9983 (French) for Canadian residents.
Once your Uconnect system is paired with a compatible mobile device, the system can
announce a new incoming text message, and read it to your over the vehicle audio system.
You can reply to the message using Voice Recognition by selecting, or saying, one of the
18 pre-defined messages.
Here’s How:
1. Push the Uconnect Phone button
and wait for the beep, then say “reply.”
Uconnect will give the following prompt: “Please say the message you would like to
send.”
2. Wait for the beep and say one of the pre-defined messages. (If you are not sure, you can
say “help”). Uconnect will then read the pre-defined messages allowed.
3. As soon as you hear the message you would like to send, you can interrupt the list of
prompts by pushing the Uconnect phone button and saying the phrase. Uconnect will
confirm the message by reading it back to you.
4. Push the Phone button and say “Send.”
PRE-DEFINED VOICE TEXT REPLY RESPONSES
Yes. Stuck in Traffic. See you later .
No. Start without me. I’ll be Late.
Okay. Where are you?
I will be <5, 10, 15,...etc.>
minutes late.
Call me. Are you there yet?
I’ll call you later. I need directions.
See you in <5, 10,
15,...etc.> of minutes.
I’m on my way .
Can’t talk right now.
I’m lost. Thanks.
NOTE:
To make the SMS voice reading function available, the SMS notification option on phone
must be enabled; this option is usually available on the phone, in the Bluetooth
connections menu for a device registered as Uconnect. After enabling this function on the
mobile phone, it must be disconnected and reconnected with the Uconnect system in
order to make it effective.
ELECTRONICS
145
To Next Page
Loading...
