WARNING!
• Driver inattention could lead to failure to
place the vehicle in PARK. ALWAYS DO A
VISUAL CHECK that your vehicle is in
PARK by verifying that a solid (not blinking)
“P” is indicated in the instrument cluster
display and on the gear selector. If the "P"
indicator is blinking, your vehicle is not in
PARK. As an added precaution, always
apply the parking brake when exiting the
vehicle.
• AutoPark is a supplemental feature. It is
not designed to replace the need to shift
your vehicle into PARK. It is a back up
system and should not be relied upon as
the primary method by which the driver
shifts the vehicle into PARK.
If the vehicle is not in PARK and the driver
turns off the engine, the vehicle may Au-
toPark.
AutoPark will engage when all of these condi-
tions are met:
• Vehicle is equipped with an 8-speed trans-
mission
• Vehicle is not in PARK
• Vehicle Speed is 1.2 MPH (1.9 km/h) or less
• Ignition switched from RUN to ACC
NOTE:
For Keyless Go equipped vehicles, The engine
will turn off and the ignition switch will change to
ACC mode. After 30 minutes the ignition
switches to OFF automatically, unless the driver
turns the ignition switch OFF.
If the vehicle is not in PARK and the driver
exits the vehicle with the engine running, the
vehicle may AutoPark.
AutoPark will engage when all of these condi-
tions are met:
• Vehicle is equipped with an 8-speed trans-
mission
• Vehicle is not in PARK
• Vehicle speed is 1.2 MPH (1.9 km/h) or less
• Driver’s seat belt is unbuckled
• Driver’s door is ajar
• Brake Pedal is not depressed
The MESSAGE “AutoPark Engaged Shift to P
then Shift to Gear”will display in the instrument
cluster.
NOTE:
In some cases the ParkSense graphic will be
displayed in the instrument cluster. In these
cases, the shifter must be returned to “P” to
select desired gear.
If the driver shifts into PARK while moving,
the vehicle may AutoPark.
AutoPark will engage ONLY when vehicle speed
is 1.2 MPH (1.9 km/h) or less.
The MESSAGE “Vehicle Speed is Too High to
Shift to P”will be displayed in the instrument
cluster if vehicle speed is above 1.2 MPH
(1.9 km/h).
WARNING!
If vehicle speed is above 1.2 MPH (1.9 km/h),
the transmission will default to NEUTRAL
until the vehicle speed drops below 1.2 MPH
(1.9 km). A vehicle left in the NEUTRAL
position can roll. As an added precaution,
always apply the parking brake when exiting
the vehicle.
Additional customer warnings will be given
when both of these conditions are met:
• Vehicle is not in PARK
• Driver’s Door is ajar
The MESSAGE “AutoPark Not Engaged” will
be displayed in the instrument cluster. A warning
chime will continue until you shift the vehicle into
PARK or the Driver’s Door is closed.
152
To Next Page
Loading...
