Metric Speed (km/h)
• Pushing the SET (-) button once will result in
a 1 km/h decrease in set speed. Each sub-
sequent tap of the button results in a de-
crease of 1 km/h.
• If the button is continually pushed, the set
speed will continue to decrease in 10 km/h
decrements until the button is released. The
decrease in set speed is reflected in the
instrument cluster display.
NOTE:
• When you override and push the SET (+)
button or SET (-) buttons, the new Set Speed
will be the current speed of the vehicle.
• When you use the SET (-) button to deceler-
ate, if the engine’s braking power does not
slow the vehicle sufficiently to reach the set
speed, the brake system will automatically
slow the vehicle.
• The ACC system applies the brake down to a
full stop when following a target vehicle. If an
ACC host vehicle follows a target vehicle to a
standstill, the host vehicle will release the
vehicle brakes two seconds after coming to a
full stop.
• The ACC system maintains set speed when
driving up hill and down hill. However, a slight
speed change on moderate hills is normal. In
addition, downshifting may occur while climb-
ing uphill or descending downhill. This is
normal operation and necessary to maintain
set speed. When driving up hill and down hill,
the ACC system will cancel if the braking
temperature exceeds normal range
(overheated).
Setting The Following Distance In
ACC
The specified following distance for ACC can be
set by varying the distance setting between four
bars (longest), three bars (long), two bars (me-
dium) and one bar (short). Using this distance
setting and the vehicle speed, ACC calculates
and sets the distance to the vehicle ahead. This
distance setting displays in the instrument clus-
ter display.
Distance Setting 4 Bars (Longest)
Distance Setting 3 Bars (Long)
Distance Setting 2 Bars (Medium)
171
To Next Page
Loading...
