Daytime Running Lights — If
Equipped
The Daytime Running Lights come on whenever
the engine is running, and the transmission is
not in the PARK position. The lights will remain
on until the ignition is switched to the OFF or
ACC position or the parking brake is engaged.
The headlight switch must be used for normal
nighttime driving.
NOTE:
If allowed by law in the country in which the
vehicle was purchased the Daytime Running
Lights can be turned on and off using the
Uconnect System, refer to “Uconnect Settings”
in “Multimedia” for further information.
Multifunction Lever
The multifunction lever is located on the left side
of the steering column.
High/Low Beam Switch
Push the multifunction lever toward the instru-
ment panel to switch the headlights to high
beams. Pulling the multifunction back toward
the steering wheel will turn the low beams back
on, or shut the high beams off.
Automatic High Beam — If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted on the
inside rearview mirror. This camera detects ve-
hicle specific light and automatically switches
from high beams to low beams until the ap-
proaching vehicle is out of view.
NOTE:
• The Automatic High Beam Headlamp Control
can be turned on or off by selecting “ON”
under “Auto High Beam” within your
Uconnect settings, as well as turning the
headlight switch to the AUTO position. Refer
to “Uconnect Settings” in “Multimedia” for
further information.
• Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer
to the vehicle). Also, dirt, film, and other
obstructions on the windshield or camera
lens will cause the system to function
improperly.
If the windshield or Automatic High Beam Head-
lamp Control mirror is replaced, the mirror must
be re-aimed to ensure proper performance. See
your local authorized dealer.
Flash-To-Pass
You can signal another vehicle with your head-
lights by lightly pulling the multifunction lever
toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
Automatic Headlights
This system automatically turns the headlights
on or off according to ambient light levels. To
turn the system on, rotate the headlight switch
counterclockwise to the AUTO position. When
the system is on, the headlight time delay fea-
ture is also on. This means the headlights will
stay on for up to 90 seconds after you place the
ignition into the OFF position.The headlight time
delay can be programmed 0/30/60/90 seconds.
Refer to “Uconnect Settings” in “Multimedia” for
further information.
To turn the automatic system off, move the
headlight switch out of the AUTO position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.
Multifunction Lever
45
To Next Page
Loading...
