To exit Valet Mode you must enter the same four digit PIN that was used to
enter the mode. The unlock keypad can be accessed by either pushing the
SR T button on the console, or pressing the “Valet” button on the touch-
screen.
The Valet Mode Deactivation key pad will then prompt you for your four digit
PIN code, enter your PIN code and press the “OK” button on the touch-
screen. Y our vehicle will return to the default state.
NOTE: If your four digit PIN is lost or forgotten, the vehicle will exit Valet
Mode after a battery disconnect for approximately five minutes. Reconnect
the battery and cycle the ignition to the RUN position, the vehicle will be in
AUTO mode.
Valet Mode Deactivation Valet Mode Deactivation PIN
SRT DRIVE MODES
33
To Next Page
Loading...
