4. Rotate the applicable bulb’s electrical connector
1
⁄
4
turn counterclockwise and remove it from the taillight
housing.
5. Remove the bulb from the connector socket and install
the replacement bulb.
6. Install the bulb and connector assembly into the
taillight housing and rotate the connector
1
⁄
4
turn clock-
wise to lock it in place.
7. Reinstall the taillight housing and fasteners.
Changing the Tail Light or Backup Light
1. Open the liftgate.
2. Remove the two fasteners retaining the taillight hous-
ing to the liftgate from the inboard face of the liftgate.
3. Carefully insert a trim stick (plastic flat-blade tool)
between the taillight housing and the liftgate. Use the
trim stick and hand pressure together to disengage the
taillight housing from the liftgate.
1 — Tail/Stop Light Bulb
2 — Rear Turn Signal Light Bulb
MAINTAINING YOUR VEHICLE 465
7
To Next Page
Loading...
