PARKSENSE REAR PARK ASSIST —
IF EQUIPPED
The ParkSense Rear Park Assist system pro-
vides visual and audible indications of the dis-
tance between the rear fascia and a detected
obstacle when backing up, e.g. during a parking
maneuver.
Refer to “ParkSense System Usage Precau-
tions” in “Starting And Operating” in your Own-
er’s Manual for limitations of this system and
recommendations.
ParkSense will retain the last system state (en-
abled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. If ParkSense is enabled
at this gear selector position, the system will
remain active until the vehicle speed is in-
creased to approximately 7 mph (11 km/h) or
above. The system will become active again if
the vehicle speed is decreased to speeds less
than approximately 6 mph (9 km/h).
ParkSense Sensors
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the ve-
hicle that is within the sensors’ field of view. The
sensors can detect obstacles from approxi-
mately 12 inches (30 cm) up to 79 inches
(200 cm) from the rear fascia/bumper in the
horizontal direction, depending on the location,
type and orientation of the obstacle.
ParkSense Warning Display
The ParkSense Warning screen will only be
displayed if “Sound and Display” is selected
from the Uconnect System. Refer to “Uconnect
Settings” in “Multimedia” in the Owner’s
Manual for further information.
The ParkSense Warning screen is located within
the instrument cluster display. It provides visual
warnings to indicate the distance between the
rear fascia/bumper and the detected obstacle.
Refer to “Instrument Cluster Display” in "Get-
ting To Know Your Instrument Panel” in the
Owner’s Manual for further information.
Enabling And Disabling ParkSense
ParkSense can be enabled and disabled using
the Uconnect System. The available choices
are: Off, Sound Only, or Sound and Display.
Refer to “Uconnect Settings” in “Multimedia”
in the Owner’s Manual for further information.
When the ParkSense button is pushed to dis-
able the system, the instrument cluster display
will show the “PARK ASSIST SYSTEM OFF”
message for approximately five seconds. Refer
to “Instrument Cluster Display” in “Getting To
Know Your Instrument Panel” in the Owner’s
Manual for further information. When the gear
selector is moved to REVERSE and the system
is disabled, the instrument cluster display will
show the “PARK ASSIST SYSTEM OFF” mes-
sage for as long as the vehicle is in REVERSE.
ParkSense System Usage Precautions
NOTE:
• Ensure that the rear bumper is free of snow,
ice, mud, dirt and debris to keep the
ParkSense system operating properly.
115
To Next Page
Loading...
