Headlights On With Wipers (Available With
Automatic Headlights Only)
When this feature is active, the headlights will
turn on after the wipers are turned on if the
headlight switch is placed in the AUTO position
and programmable feature is set to ON. In
addition, the headlights will turn off when the
wipers are turned off if they were turned on by
this feature.
NOTE:
The Headlights On with Wipers feature can be
turned on or off using the Uconnect System.
Refer to “Uconnect Settings” in “Multimedia”
in your Owner’s Manual for further information.
Headlight Time Delay
This feature provides the safety of headlight
illumination for up to 90 seconds when leaving
your vehicle in an unlit area.
To activate the delay feature, turn OFF the
ignition switch while the headlights are still on.
Then, turn off the headlights within 45 sec-
onds. The delay interval begins when the head-
light switch is turned off.
NOTE:
The lights must be turned off within 45 seconds
of turning the ignition OFF to activate this fea-
ture.
If you turn the headlights, parking lights or
ignition switch ON again, the system will cancel
the delay.
If you turn the headlights off before the ignition,
they will turn off in the normal manner.
NOTE:
The Headlight Time Delay is programmable us-
ing the Uconnect System, refer to “Uconnect
Settings” in “Multimedia” in your Owner’s
Manual for further information.
Fog Lights — If Equipped
The front fog light switch is built into the head-
light switch.
To activate the front fog lights, turn on
the parking lights or the low beam
headlights and push the headlight
switch. To turn off the front fog lights, either
push the headlight switch a second time or turn
off the headlight switch.
An indicator light in the instrument cluster illu-
minates when the fog lights are turned on.
NOTE:
The fog lights will operate when the low beam
headlights or parking lights are on. However,
selecting the high beam headlights will turn off
the fog lights.
Turn Signals
Move the multifunction lever up or down and
the arrows on each side of the instrument clus-
ter display flash to show proper operation of the
front and rear turn signal lights.
NOTE:
• If either light remains on and does not flash,
or there is a very fast flash rate, check for a
defective outside light bulb. If an indicator
fails to light when the lever is moved, it would
suggest that the indicator bulb is defective.
• A “Turn Signal On” message will appear in the
instrument cluster display and a continuous
chime will sound if the vehicle is driven more
than 1 mile (1.6 km) with either turn signal
on.
GETTING TO KNOW YOUR VEHICLE
28
To Next Page
Loading...
