HOOD
Opening
Two latches must be released to open the hood.
1. Pull the hood release lever located under the
left side of the instrument panel.
2.
Outside of the vehicle, locate the safety latch
lever near the center of the grille between the
grille and hood opening. Push the safety latch
lever to the left and raise the hood.
3.
Use the hood prop rod to secure the hood in the
open position. Place the upper end of the prop
rod in the hole on the underside of the hood.
Closing
WARNING!
Be sure the hood is fully latched before
driving your vehicle. If the hood is not fully
latched, it could open when the vehicle is in
motion and block your vision. Failure to fol-
low this warning could result in serious injury
or death.
CAUTION!
To prevent possible damage:
• Before closing hood, make sure the hood
prop rod is fully seated into its storage
retaining clips.
• Do not slam the hood to close it. Use a firm
downward push at the center front edge of
the hood to ensure that both latches en-
gage. Never drive your vehicle unless the
hood is fully closed, with both latches
engaged.
LIFTGATE
Opening
The liftgate can be unlocked or locked pushing
the unlock or lock button on the Remote Key-
less Entry key fob, the Keyless Enter-N-Go (Pas-
sive Entry) lock/unlock button underneath the
left side of the accent bar, which is located on
the liftgate below the glass or by activating the
power door lock switch located on either front
door trim panel.
Refer to “Keyless Enter-N-Go” in “Getting To
Know Your Vehicle” for further information on
Keyless Enter-N-Go (Passive Entry).
NOTE:
The liftgate cannot be unlocked or locked with
the manual door lock plungers on the door trim
panels or the door lock cylinder on the driver's
door.
To open the unlocked liftgate, squeeze the
handle and pull the liftgate toward you. Gas
props will raise and support the liftgate in the
open position.
Hood Release Lever Location
GETTING TO KNOW YOUR VEHICLE
46
To Next Page
Loading...
