To reset the inverter manually press the power
inverter button OFF and ON. To avoid overload-
ing the circuit, check the power ratings on
electrical devices prior to using the inverter.
NOTE:
Due to built-in overload protection, the power
outlet will shut down if the 115 Volt AC
(150 Watt maximum) power rating is exceeded.
WARNING!
To avoid serious injury or death:
• Do not use a three-prong adaptor.
• Do not insert any objects into the recep-
tacles.
• Do not touch with wet hands.
• Close the lid when not in use.
• If this outlet is mishandled, it may cause
an electric shock and failure.
Power Inverter Operation
The power inverter is turned On and Off using
the Uconnect System.
Vehicles Equipped With Radio 4.3
To turn the power inverter on or off perform the
following:
1. Press the “More” button on the faceplate
(located next to the Uconnect display).
2. Press the “Outlet” button on the touch-
screen (located on the Uconnect display) to
turn the power inverter On or Off.
Vehicles Equipped With Uconnect 3/3 NAV
To turn the power inverter on or off perform the
following:
1. Press the “Controls” button on the
touchscreen.
2. Press the “Outlet” button on the touch-
screen to turn the power inverter On or Off.
ROOF LUGGAGE RACK — IF
EQUIPPED
The roof rack cross rails and side rails are
designed to carry cargo weight. The load must
not exceed 150 lbs (68 kg), and it should be
distributed uniformly over the cross rails. In
addition, the roof rack does not increase the
total load carrying capacity of the vehicle. Be
sure the total load of cargo inside the vehicle
plus that on the roof rack does not exceed the
maximum vehicle load capacity.
NOTE:
The roof rack side rails on your vehicle are NOT
designed to carry a load without the addition of
crossbars.
Metal crossbars are offered by Mopar accesso-
ries to provide a functional roof rack system. See
an authorized dealer.
To Move The Crossbars
1. Loosen the knobs on top of each crossbar
approximately six turns to disengage the
clamp tooth from the side rail.
55