the station found was previously stored in memory,
the display will show the channel where it is stored
and the tuned station.
Mute/Pause
Pushing this button mutes the sound. The display will
switch between ⬙MUTE ON⬙ and the previous display (3
seconds).
Pushing the button again restores the audio without
changing the original volume setting. The display will
show ⬙MUTE OFF⬙ for three seconds, and then return to
the previous display mode.
When the
or , Audio, 1, 2, 3, 4, 5, 6, BAND/AS
buttons and SRC are pushed in ⬙Mute/Paused⬙ mode,
these will be implemented and the audio will be
restored without changing the original volume.
Turn the ROTARY knob to restore the audio and change
the volume to the level selected. The display will show
the settings described in the volume function.
The other buttons should be implemented when pushed,
but the radio will remain in ⬙MUTE ON⬙ mode.
Storing Stations In Memory
Push and hold the memory buttons (1 through 6) for
more than two seconds to associate the tuned station
with the pushed button. The display will show a message
in ⬙MEMO 2⬙ format for three seconds to confirm that the
station has been tuned in. The CH signal is then activated
and the display will show the preset number and station
frequency for three seconds ⬙2 106.9⬙. The display will
then return to the previous view.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 179
To Next Page
Loading...
