98 GETTING TO KNOW YOUR VEHICLE
TRI-FOLD TONNEAU COVER
I
NSTALLATION
To install the Tonneau Cover follow the following
steps:
1. Position the folded Tonneau Cover on the
truck bed and push the cover forward against
the front of the truck bed. The Tonneau Cover
centers itself when placed on the vehicle.
NOTE:
Make sure to always push the Tonneau Cover all
the way forward on the truck bed. Failure to do so
might prevent proper clamp engagement, or
interfere with the electronic tailgate release
function (if equipped).
Location Of Front Latches
2. Pull down on the first set of clamp handles to
release the clamps from the Stowed Position.
Stowed Position
3. Push clamp wires up and under the flange of
the box (or flange of the Ram Box rail, if
equipped) to the Semi-Clamped Position.
Semi Clamped Position
4. Push clamp handles upward to the clamped
position to properly engage the clamps.
Clamped Position
NOTE:
Once clamped, be sure the clamps are not
improperly attached to the truck bed flange.
Improper Clamp Position
22_DJD2_OM_EN_USC_t.book Page 98
To Next Page
Loading...
