Dodge RAM 2500 2022 - Tri-Fold Tonneau Cover - if Equipped; Tri-Fold Tonneau Cover Removal

GETTING TO KNOW YOUR VEHICLE 95
4. Rotate the center handle horizontally to secure
the side gates in the closed position.
Side Gates Closed
5. Lock the center handle to secure the panel
into place.
Storage Position
The storage position for the bed divider is at the
front of the truck bed which maximizes the bed
cargo area when not in use.
To install the bed divider into the storage position,
perform the same steps as you would for the
divider position, except position the divider fully
forward in the bed against the front panel.
Storage Position
The outboard ends should be positioned in front of
the cargo tie-down loops.
Cargo Tie-Down Loop
TRI-FOLD TONNEAU COVER — IF EQUIPPED
The Tri-Fold Tonneau Cover can be installed on the
truck bed to protect your gear and cargo.
TRI-FOLD TONNEAU COVER REMOVAL
To remove the Tonneau Cover, use the following
steps:
1. Open the tailgate to gain access to the rear
pair of Tonneau Cover clamps located on the
underside of the cover.
Location Of Rear Latches
NOTE:
If clamp wire is damaged replace immediately.
2
22_DJD2_OM_EN_USC_t.book Page 95