TEST ACTION APPLICABILITY
4 Disconnect the Driver Cylinder Unlock Switch connector.
Measure the voltage between the Driver Cylinder Unlock Switch Mux circuit and
ground.
Is the voltage above 4.9 volts?
All
Yes → Replace the Driver Cylinder Unlock Switch.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Driver Cylinder Unlock Switch Mux circuit for a
partial short to ground.
Perform BODY VERIFICATION TEST - VER 1.
300
POWER DOOR LOCKS/RKE
DRIVER CYLINDER UNLOCK SWITCH STUCK — Continued
To Next Page
Loading...
