TEST ACTION APPLICABILITY
13 Remove the Passenger Window Up Relay.
Measure the voltage of the Fused B+ circuit in the Passenger Window Up Relay
connector.
Is the voltage above 10.0 volts?
All
Yes → Replace the Relay.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Fused B+ circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
14 Remove the Passenger Window Up Relay (located under the dash just above the
steering column).
Using a 12-volt test light connected to ground, check the Passenger Window Up Relay
Control circuit.
With the DRBIIIt, actuate the PASS WINDOW UP.
Does the test light illuminate brightly when the PASS WINDOW UP circuit is
actuated?
All
Yes → Go To 15
No → Go To 16
15 Remove the Passenger Window Up Relay.
Using a 12-volt test light connected to 12-volts, check both of the Passenger Window
Up Relay Ground circuits.
Does the test light illuminate brightly when connected to both the Ground circuits?
All
Yes → Replace the Passenger Window Up Relay.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Passenger Window Relay Coil Ground for an open.
Perform BODY VERIFICATION TEST - VER 1.
16 Remove the Passenger Window Up Relay (located under the dash just above the
steering column).
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Passenger Window Up Relay Control circuit between
the BCM C2 connector and the Relay connector..
Is the resistance below 5.0 ohms?
All
Yes → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Passenger Window Up Relay Control circuit for an
open.
Perform BODY VERIFICATION TEST - VER 1.
370
POWER WINDOWS
*PASSENGER WINDOW INOPERATIVE — Continued
To Next Page
Loading...
