TEST ACTION APPLICABILITY
4 NOTE: This test will determine if programming the sensor completed the
repair.
Disconnect the DRBIIIt.
Drive the vehicle for about 10 minutes above 33 km/h (20 mph).
Stop vehicle.
Connect the DRBIIIt.
Turn the ignition on.
With the DRBIIIt, read the last 32 transmissions.
Does the DRBIIIt display transmissions from the affected Tire Pressure Sensor/
Transmitter?
All
Yes → The repair is complete.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
No → Replace and program the Tire Pressure Sensor/Transmitter in
accordance with the Service Information.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
5 Turn the ignition off.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wire harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Refer to any Hotline letters or Technical Service Bulletins that may apply.
Were any problems found?
All
Yes → Repair as necessary.
Perform TIRE PRESSURE MONITORING SYSTEM VERIFICA-
TION TEST.
No → Test Complete.
374
TIRE PRESSURE MONITORING
LEFT FRONT TIRE PRESSURE SENSOR/TRANSMITTER - TPM —
Continued
To Next Page
Loading...
