Need help?Do you have a question about the Dog & Bone Wetsuit and is the answer not in the manual?
General| Waterproof Rating | IP68 |
|---|---|
| Compatible Brand | Apple |
| Waterproof | Yes |
| Touchscreen Compatibility | Yes |
| Color Options | Black, Blue, Pink |
| Type | Case |
| Features | Waterproof, Shockproof |
| Compatibility | iPhone 6/6s |
| Closure | Snap |
Take case from packaging and attach test block to the top cover perimeter.
Submerge case in water, weigh down, and remove after 15 minutes.
Check for water inside and on test block; re-test or contact support if needed.
Wipe and dry the exterior of the case before opening seals or ports.
Watch the official video for careful removal instructions.
Use a coin to open the case at the corner and follow the perimeter.
Ensure all screen films are removed from the handset before assembly.
Insert handset into rear cover, set silent switch, and clip on top cover.
Firmly clip perimeter, remove trapped air, secure port plugs, and inspect seals.
Case is not indestructible; avoid damage from drops, chemicals, etc. Follow instructions carefully.
Information regarding product origin, patents, and non-endorsement by Apple.
To Next Page