Need help?Do you have a question about the Doka Staxo 40 and is the answer not in the manual?
General| Brand | Doka |
|---|---|
| Model | Staxo 40 |
| Category | Security Sensors |
| Language | English |
Other use requires prior approval; lifting other manufacturers' towers is forbidden.
Lists operations such as lifting, wheeling, lining-and-levelling, and lowering.
Provides key measurements (a, b, c, d, e) for the shifting wheel and its components.
Details designation, art. no., dead weight, max. load, and year of manufacture.
Inspect for damage, deformation, cracks, heat damage, and ensure rating plate is legible.
Lifting accessories require expert inspection at least annually or per national regulations.
Store in a dry, ventilated area protected from weather and corrosive substances.
Requires flat firm floor, limits trackway inclination to 2%, bridge openings, keep route clear.
Adjust screw-jack feet to dimension 'a' and secure them to frames with anti-dropout locks.
Fix the adjusting bracket to the bottom frame using a D16/125 bolt and linch pin.
Illustrates bracket positions for various frame sizes (0.90m, 1.20m, 1.80m).
Bolt shifting-wheel to frame with two D16/125 bolts and secure with linch pins.
Use the screwjack mechanism to lift the tower a maximum of 5 cm off the ground.
Open split nut via quick-locking device to lower the swivel caster to the ground.
Includes notices on height offsets, steps, wind, passenger transport, and speed limits.
Follow directions in the "Staxo load-bearing tower 40" User Information booklet for crane lifting.
Lower the tower onto the ground by turning the screwjack mechanism; do not open split nut when loaded.
Declares compliance with EC Directive 2006/42/EC and lists applied harmonised standards.
To Next Page
