3
Position the rearview into the top section.
Using moderate force push downwards
until it locks in the top section.
Fitting the seat pad
Attaching the toy tray
Attaching the rearview
2xAA size Alkaline batteries are needed
for the toy (batteries no included) .Unfold
the walker and place the toy tray into
position. Push the locking keys located
on the underside of the walker tray up
and turn around to secure the toy tray
to the walker. The toy should be
assembled by adult.
Thread the 4 seat clips through the corresponding
holes in the top tray. Once the clips have been thread
through the holes turn each of them 90 degress on
the underside of the play.Please make sure each clip
is fully secured.
To Next Page
Loading...