IF SERVICE OF THIS TOILET IS EVER REQUIRED,
READ THIS BEFORE SERVICING PRODUCT.
DO NOT REMOVE TOILET FROM VEHICLE.
DO NOT SEPARATE CERAMIC BOWL FROM PLASTIC BASE.
DO NOT REMOVE FOOT PEDAL FROM BASE.
DISASSEMBLY OF COMPONENTS MAY VOID WARRANTY.
SEE MANUAL AND REPLACEMENT KITS FOR SERVICE INFORMATION.
Dometic Corporation
Sanitation Division
Call Customer Service: 1-800-321-9886 (8 a.m. – 5 p.m. ET)
TOILET DOES NOT NEED TO BE REMOVED FROM VEHICLE FOR BASIC REPAIRS (if necessary)
Factory-sealed bowl-to-base
assembly – Unlike other
Dometic foot-pedal toilets, the
bowl and base of 300, 310,
and 320 series toilets should
not be separated for any
reason.
Each Dometic toilet is factory-tested to assure a
watertight seal in toilet bowl before it is shipped.
After installation at the RV or other vehicle factory, the
entire toilet system is tested for leaks. This process
requires holding the ush ball open with a device which
may temporarily distort the ball seal from its original
shape and, as a result, cause the seal to leak water into
the waste tank during normal use. The ball seal may need
to be reconditioned to its original shape.
IF NEW TOILET DOES NOT HOLD WATER IN BOWL…
Please follow the procedures below before attempting to
replace the seal.
1. Hold ush ball open by pressing on pedal.
2. Using nger, apply moderate downward pressure around
edge of ball seal.
3. Close ush ball.
4. Keeping ush ball closed, pour one quart of hot tap water
into toilet bowl.
5. Let water cool completely.
6. Check for leak.
If leak still persists, ush ball seal should be replaced.
Follow instructions provided with replacement seal kit.
IMPORTANT INFORMATION
To Next Page
Loading...
Need help?
General
