15
EN
Toilets
Replacing the rotor sha
➤ Follow the disassembly steps in “Replacing the flush ball” on page 14.
➤ Pull the rotor sha out from inside the base.
➤ Lubricate the O-rings on the new sha with silicone grease.
➤ Align the flat section on the rotor sha with the flat section in the ca. Push the rotor sha cam
fully onto the rotor-sha. Tighten the set screw.
➤ Lubricate moving parts with silicone grease.
➤ Reverse the disassembly procedure.
➤ Before attaching the base to the toilet, the cam switch may require adjustment. See “Aligning
Cam Switch/Flush Ball” on page 13.
Replacing the rotor sha cam
➤ Follow disassembly steps under “Replacing the flush ball” on page 14.
➤ Remove the linkage pin clip and pin.
➤ Attach the new rotor sha cam to the linkage, using the pin and clip.
➤ Lubricate moving parts with silicone grease.
➤ Reverse the disassembly procedure.
➤ Before attaching the base to the toilet, the cam switch may require adjustment. See “Aligning
Cam Switch/Flush Ball” on page 13.
Replacing the motor drive arm
➤ Follow the disassembly steps in “Replacing the flush ball” on page 14.
➤ Remove the four motor-mounting screws.
➤ Remove the motor from the mounting bracket.
➤ Loosen the drive-arm set screw using a 3/32-inch hex tool, then remove the old drive-arm.
➤ Install the new drive arm and push it onto the motor sha as far as possible. Tighten the set
screw.
➤ Lubricate moving parts with silicone grease.
➤ Reverse the disassembly procedure.
➤ Before attaching the base to the toilet, the cam switch may require adjustment. See “Aligning
Cam Switch/Flush Ball” on page 13.
Replacing the drive linkage
➤ Follow the disassembly steps in “Replacing the flush ball” on page 14.
➤ Remove the linkage pin clip and pin at the rotor sha cam.
➤ Remove the flush spring retaining screw and washer from the retaining post.
➤ Remove the flush spring from the old linkage.
➤ Insert the flush spring into the new linkage, and reattach the spring to the retaining post.
➤ Attach the linkage to rotor sha cam using the pin and clip.
➤ Lubricate moving parts with silicone grease.
➤ Reverse the disassembly procedure.
To Next Page
Loading...
