Dometic 4000 Series - Page 5

5
EN
Toilets
3.2 Using the flush handle (4700 models only)
3
Flush Handle
➤ Li the flush handle to fill the bowl to the
desired water level.
4
Flush Handle
➤ Press the flush handle down, then release it
to flush the toilet.
3.3 Understanding the indicator lights for 4500, 4600, 4700, and 4800
Indicator Light Status
Power on Steady green Electrical power to the toilet is
activated
Flashing green The flush mode is changing
Tank level Amber The holding tank is 75% full
Red The holding tank is 100% full*
*Flush actuation is disabled to prevent overfilling the holding tank
3.4 Changing the flush modes for 4500, 4600, 4700, and 4800
Flush modes Action Gallons per flush
Normal Adds water to the bowl aer
every flush
1 quart (0.95 liters)
Dry bowl Does not add water to the
bowl aer every flush
1 pint (0.5 liters)
➤ To change modes, press the Flush switch or handle until the power-on light begins flashing
(about five seconds).
➤ Release the Flush switch or handle.
3.5 Service Mode
To clean the toilet bowl or seals, or to perform other servicing that requires keeping the flush ball
open without running water, use the Service switch.
➤ Push and hold the Service switch for three seconds.
➤ Perform the required servicing.
➤ Aer servicing is complete, push and hold the Service switch for three seconds to change
back to normal operation.