16
EN
Service Procedures Refrigerators
7.7 Replacing the Lower Latch Catch
12 Replacing the Lower Latch Catch
1. Locate and remove the Phillips-head screw securing
the lower latch catch to the bottom of the unit.
2. Locate and remove the six T20 Torx-head screws
securing the lower latch catch to the bottom of the
unit.
3. Remove the bottom latch catch.
4. Complete these steps in reverse order to install the
new lower latch catch.
I
Refer to Adjusting the Door on page 14 to
properly adjust the lower latch catch.
7.8 Replacing the Door Panel
13 Replacing the Door Panel
๎
CAUTION: CUT HAZARD.
The metal door panel is very sharp, so use care
when handling. Failure to obey this caution could
result in minor or moderate injury.
1. With the door open, gently slide the door panel up
and out of the door frame.
2. To install the new door panel, carefully align it with
the grooves in the door frame, and gently slide it
down until properly seated.
To Next Page
Loading...
