Dometic CD20 - Replacing the Condenser Fan; Replacing the Thermostat Assembly

17
EN
Refrigerators Service Procedures
7.9 Replacing the Condenser Fan
14 Replacing the Condenser Fan
1. Disconnect the unit from power.
2. Disconnect the fan wires from the control module
terminals marked with "F" and a small "+" symbol.
3. Locate and remove the two screws securing the fan to
the condenser.
4. Remove the fan from the unit.
I
If the condenser fins show debris or dirt, clean them
at this time. Refer to Maintenance on page 23 for
details.
5. Complete these steps in reverse order to install the
new condenser fan.
7.10 Replacing the Thermostat
Assembly
This section describes how to replace the thermostat
assembly on CRX, CR, and CD series refrigerators. Refer
to the appropriate section for details.
7.10.1 Replacing CRX Series Thermostat
Assemblies
15 Removing the Thermostat Sticker
1. Carefully pry the adhesive control panel film from the
existing assembly.
I
The adhesive control panel film will not be reused.
16 Removing the Thermostat Assembly
2. Locate and remove the six screws securing the plastic
cover of the PCB.
3. Carefully pull the cover off, and the PCB will come
with it.