Safety instructions CoolMatic
14
!
WARNING!
• Before you start up the appliance for the first time, check that the
operating voltage matches the battery voltage (see type plate).
• If the connection line of this device is damaged, it must be replaced
with a special connection line which is available from the manufacturer
or customer service.
• Have a trained technician do the installation in wet rooms.
• Do not operate the appliance if it is visibly damaged.
• This appliance may only be repaired by qualified personnel. Improper
repairs can lead to considerable hazards.
A
NOTICE!
• Warning: do not open or damage the refrigerant circuit under any
circumstances.
• Set up the appliance in a dry location where it is protected against
splashing water.
• Do not place the appliance near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.)
• Ensure that the ventilation slots are not covered.
• Do not store any explosive substances, such as spray cans with
propellants in the device.
2.2 Operating the appliance safely
D
DANGER!
• Danger of fatal injury!
Do not touch exposed cables with your bare hands. This especially
applies when operating the appliance from an AC mains.
!
WARNING!
• Disconnect the refrigerator and other electric loads from the battery,
before you connect the battery to a quick charging device.
Overvoltage can damage the electronics.
• People (including children) whose physical, sensory or mental capac-
ities or whose lack of experience or knowledge prevent them from
using this product safely should not use it without the supervision or
instruction of a responsible person.
CR50-65-80-110-140--O-US.book Seite 14 Donnerstag, 13. Oktober 2016 2:37 14
To Next Page
Loading...
