Installing and connecting the refrigerator CoolMatic
20
7.3 Undo the lock
The refrigerator has a locking mechanism (fig. 9 1, page 6) which is also used, to
protect it during transport. The following settings are possible:
A
• Lock (turn wheel clockwise to the end stop): The door is locked and secured.
To open the door, lift the handle up and open it.
• Vent (turn wheel anti-clockwise to the end stop): The door is slightly open, but
fixed in position.
Use this position, if you are not going to use the appliance for a long time.
7.4 Changing the door hinge
You can also change the hinge of the door, so that it opens to the left rather than the
right.
➤ Proceed as shown in fig. b, page 7 to fig. d, page 7, to change the hinges.
7.5 Connecting the refrigerator
Connect the refrigerator to DC power
The refrigerators can be operated with 12 Vg or with 24 Vg.
A
➤ Determine the required cross section of the cable in relation to the cable length
according to fig. e, page 8.
Key for fig. e, page 8
NOTICE!
Only adjust the locking mechanism when the door is open. If you use it
with the door closed, you will damage the device.
NOTICE!
To avoid voltage drops and loss of performance, keep the cable as short
as possible and avoid joins.
For this reason avoid additional switches, plugs or multi-way adapters.
Co-ordinate axis Explanation Unit
l Cable length m
∅ Cable cross section mm²
CR50-65-80-110-140--O-US.book Seite 20 Donnerstag, 13. Oktober 2016 2:37 14
To Next Page
Loading...
