Dometic COOLMATIC Series - Installing and Connecting the Refrigerator; Installation on Boats; Door Hinge Adjustment

EN
HDC275 Installing and connecting the refrigerator
17
7 Installing and connecting the
refrigerator
Please note the following instructions for installation on boats:
D
A
7.1 Changing the door hinge
You can also change the hinge of the doors, so that the doors open to the left rather
than the right.
➤ Unscrew and remove the top bolts (fig. 2 1, page 3).
➤ Remove the upper door (fig. 2 2page 3).
➤ Remove the spacer (fig. 2 3, page 3).
➤ Remove the middle hinge (fig. 3 1, page 3).
➤ Remove the lower door (fig. 3 2page 3).
➤ Unscrew and remove the bottom bolts (fig. 4 1, page 4).
On the opposite side:
➤ Fasten the bottom bolts.
➤ Attach the lower door.
➤ Fasten the middle hinge firmly.
➤ Fit the spacer.
➤ Attach the upper door.
➤ Fasten the top bolts.
DANGER!
If the device is powered by the mains, ensure that the power supply has
a residual current circuit breaker.
NOTICE!
The device can be tilted sideways up to 30°. When setting up the
refrigerator, note that it must be fastened to take account of this. If you
have any questions regarding installation, consult your specialist dealer.
HDC275-IO-West.book Seite 17 Dienstag, 14. März 2017 8:41 20