D15, D50, D52 Using the appliance
21
Using drinks mode (only D52)
The temperature range in drinks mode is between 2 °C and 6 °C (36 °F and 43 °F).
➤ Press the ,
and buttons simultaneously for at least 5 seconds.
✓ The temperature indicator flashes 5 times.
Checking the set temperature
This is how to display the set temperature:
➤ Press the or button briefly.
✓ The set temperature is shown in the display for 5 seconds.
Then the display shows the current inner temperature again.
I
Temperature monitoring
A warning signal sounds and the temperature display flashes:
• if the inner temperature of a zone deviates from the set temperature by more
than 5 °C (41 °F).
• if the power supply has been disconnected for a long time.
• if the door has not been shut properly.
• if the door is open for more than 60 seconds.
This prevents the temperature from falling or rising unnoticed, which could affect
the quality of the wine.
Once the unit has reached the set temperature, the warning signal stops and the
temperature display stops flashing.
To switch off the warning signal prematurely:
➤ Press the
button briefly.
✓ The temperature display flashes until the set temperature is reached. The display
is then illuminated constantly and indicates that the alarm system is active again.
NOTE
In the event of an interruption to the power supply (power failure, switch
over) the unit saves the previous temperature settings.
D15-D50-D52-O-12s.book Seite 21 Donnerstag, 27. April 2017 5:29 17
To Next Page
Loading...
Need help?
General
