- 4 -
LOADING THE WINE CELLAR
Bottles should be stored in your wine cellar
according to their size (diameters and heights).
Take these differences into account when storing
your wine and avoid mixing the bottles.
It is important to store bottles on their side in
order for the cork to remain in contact with the
wine.
Note that you should store no more than one
layer of bottles on the shelves.
The maximum number of bottles (“Bordeaux
Tradition”) that can be stored in the wine cellar:
If the wine cellar fails to work, check the follow-
ing points before calling a service technician:
• Is the fuse of power supply intact?
• Is the plug properly inserted in its socket?
• Is the wine cellar switched on?
If the cause of failure is not to be found among
the points listed above, contact an authorised
service technician.
The wine cellar is equipped with an overheating
protection. An authorised service technician can
check whether this has been triggered or not.
SHELF SUPPORTS AND SHELF LOCKS
The wine cellar is equipped with 4 shelves and 16
shelf supports. The shelves are at delivery xed to
the side of the wine cellar with a shelf lock. These
can easily be removed with a screwdriver.
To install the shelf supports, place the support
hooks in front of the desired holes, press in direc-
tion of arrow 1 and then, push the hook down as
arrow 2 indicates.
1.
2.
Number of shelves Number of bottles
4 25
0 36
CAUTION
FRONT PROFILE TOP
To Next Page
Loading...
Need help?
General
