Dometic NDA1402 - Appendix B - Consumer Support; Registering Your Appliance

20
Number Instruction Note
00 — —
01 LED panel check All LED segments ON
02 Battery voltage check ”12” → in range between 8,5 - 18 V DC.
“Lo” or “hl” → out of range
03 Air temperature Value in °F → in range, “hl” or “Lo” → out of range, “--” → sensor faul
t
sensors, freezer + fridge
04 Surface temperature Value in °F → in range, “hl” or “Lo” → out of range, “--” → sensor faul
t
sensors, freezer + fridge
05 Door switches status ”OP” → open, “CL” → closed
06 Turn AC heater ON ”ON” → turned on, “no AC” → problem
07 Turn fridge heater ON ”ON” → turned on, “--” → problem
08 Turn freezer heater ON ”ON” → turned on, “--” → problem
09 Turn drain heater ON ”ON” → turned on, “--” → problem
10 Turn door heater ON ”ON” → turned on
11 Turn fridge fan ON ”ON” → turned on, “--” → problem
12 Turn freezer fan ON ”ON” → turned on, “--” → problem or “bL” → blocked
13 Turn gas ignition system ON ”FL” → turned on flame, “l9” → sparking, “--” → problem
SERVICE MODE
Service mode is intended as a tool for service personnel only in order to perform diagnostic troubleshooting.
1. Before entering service mode, switch off the refrigerator with the ON/OFF key.
2. To enter service mode, press and hold SET key, then press ON/OFF key.
3. Press SET key to toggle the list of functions step by step.