This manual describes how to install NEAl 402 (all-electric operation) and NDA1402 (2-way operation). These models can be
equipped with an ice maker, an ice dispenser or ice
&
water dispensers.
The information in this manual is intended for qualified technicians with knowledge and experience of absorption refrigerators
and LP gas systems. For operating instructions, please refer to the User manual for the appliance in question.
Read this manual before installing the refrigerator. Comply with installation specifications and dimensions. Follow the instructions
to ensure that the refrigerator is installed safely and that it runs efficiently. Be aware of possible safety hazards when seeing alert
symbols on the refrigerator as well as in this manual.
The appliance is certified under the latest edition of ANSI Z21.19·CSA
104
Refrigerators using gas fuel. The installation must
conform with local codes, or in absence of local codes, the following standards as applicable.
In the U.S. the installation must conform with:
• National Fuel Gas Code, ANSI Z223 .IINFPA 54 (latest edi-
tion).
• Recreational Vehicles Code, ANSI A 119.2 (latest edition)
• Manufactured Home Construction and Safety Standard, Title
24 CFR, Part 3280.
If an external electrical source is utilized, the refrigerator, when
installed, must be electrically grounded in accordance with lo-
cal codes or, in the absence of local codes, the National Electri-
cal Code, ANSIINFPA 70 - (latest edition).
In CANADA, the installation must conform with:
• Natural Gas and Propane Installation Code, CSA B 149.1
• CSA Z240 RV Series, Recreational Vehicles.
• Current CSA
Z24004,
Gas-equipped Recreational Vehicles
and Mobile Housing.
If an external electrical source is utilized, the refrigerator,
when installed, must be electrically grounded in accordance
with local codes or, in the absence of local codes, the Canadian
Electrical Code, CSA C22.1, Parts I and II - (latest edition).
@.
C US
GENERAL INFORMATION
Provide necessary air circulation over the cooling unit. Open-
ings for air supply or for venting of combustion products shall
have a minimum dimension of not less than 1/4 inch.
Certified installations require one roof vent and one lower side
vent. Proper installation requires one lower fresh air intake
and one upper exhaust vent. The ventilation kits shown in this
manual have been certified for use with NEA1402 and
NDA1402. The ventilation kits must be installed and used
without modification.
Certified vent system kits
Kit no.
Components
Part no.
5A Roof Base
3103633.xXX*
Roof Cover 3103634.XXX*
Lower Side Vent
3109349.XXX*
Power Vent Asm.
3108705.744**
*
Fill in '~\XX" with color code numbers. For color codes, contact
your supplier.
**
Alternate instructions forwarded with the Ventilator Kit.
The lower vent of the recommended kits is provided with
proper size openings. The flow of combustion and ventilating
air must not be obstructed.
CAUTION
It is of especially importance tbat tbe airflow around
tbe burner housing, tbe boiler insulation and tbe
flow of combustion gases must not be obstructed.
Items placed in
the
vicinity of
the
refrigerator
compartment accordingly must be secured away
from the refrigerator tubing and flue.
The lower side vent is fitted with a panel, which provides an
adequate access opening for ready serviceability ofthe burner
and control manifold of the refrigerator. This should be cen-
tered on the back of the refrigerator.
'~I_-------:::=-==--_-----.JI""'"
vent cutout
28-518·
- 3 -
To Next Page
Loading...
