9
11. Igniting the gas burner (Fig. 5, 6, 7.)
1. Energy selector switch (A) should be in position 'Gas'.
2. Open gas cylinder or pressure regulating valve.
3. Turn thermostat knob (C) to the MAX position, press and hold down.
4. After approximately 10 seconds press knob (D) several times. In case of
appliances equipped with electronic ignition, the knob has to be held pushed
down continuously for some seconds. (E) (This could take longer than 10
seconds if the unit has been out of operation for a prolonged period or after
replacing the gas cylinder. Cause: air in the pipes.)
5. After ignition, hold down knob (C) for a further 20-30 seconds before
releasing.
The flame can be controlled by flame indicator (B). The needle of the
galvanometer passes over into the green section.
6. Should no ignition occur, repeat the ignition process after 1 minute.
7. After sufficient cooling (approximately 5 hours), the thermostat position can
be set to a lower temperature. (Middle position) The thermostat will now
automatically regulate the set temperature.
D
Figure 5 Figure 6
Figure 7
A
max
position
C
E
max
position
C
middle position
middle position
To Next Page
Loading...
