17
4.7 Operation RM 8xx5 models
4.7.1 Explanation of operating controls
Fig. 10
Manual operation
Select energy source with buttons (2,3,4)
Set temperature step by pressing button (6)
Switching ON/OFF
Switch ON by pressing button (1), 2s
Switch OFF by pressing button (1), > 2s
Automatic operation
Change over to “Automatic” with button (5)
Set temperature step by pressing button (6)
Automatic energy selection / automatic
ignition (RM 8xx5) AES :
= Power ON/OFF switch
= Energy selector button 120V ~
= Energy selector button GAS
= Energy selector button 12V =
= Selector button “AUTOMATIC”
= Temperature level selection
= Temperature level display
= Indicator LED failure /
Reset button GAS FAILURE
2
1
3
4
5
6
7
8
1 2 3 4 5 6 8
7
4.6.4 Setting of cooling compartment
temperature
Fig. 9
Select the desired cooling compartment tem-
perature by pressing button (6) .
The LED display (7) of the selected temperatu-
re setting is illuminated.
The scale starts with MIN position at the left
LED position (small bar = highest temperature)
and climbs up to MAX position at the right
LED position (large bar = lowest temperature).
Note: The temperature levels do not relate to
absolute temperature values.
6
7
To start the refrigerator, press button (1) for 2
seconds.
120V operation :
Press button (2) :
12V operation :
Press button (4) :
Gas operation :
Press button (3) :
Fig. 11
4.7.2 Manual operation
1
2
43
Refrigerator operation
289 0317-13_USCD_EN_RMx8xxx-Operation_N2_Layout 1 03.02.2014 08:05 Seite 17
To Next Page
Loading...
