Installing the refrigerator RM10.5(S)(T), RMS10.5(X)(S)(T)
24
If you have to use a roof vent instead of the air outlet vent:
➤ Cut out a section in the roof. Refer to the roof vent instruction manual for the
required dimensions.
When doing so, observe the information in chapter “Preparing the installation”
on page 20.
5.4 Installing the ventilation grille
I
1. Seal the installation frame to make the connection waterproof (fig. b, page 9).
2. Insert the installation frame and screw it down tightly (fig. c, page 9). Use all
the fixing holes for this.
3. Install the hose adapter as shown (fig. d 1, page 10).
4. Insert the ventilation grille as shown (fig. e, page 10).
5.5 Installing condensation drain
I
Install the condensation drain as follows:
➤ Attach the condensation hose directly to the adapter on the ventilation grille
(fig. d 2, page 10).
NOTE
Use exclusively original Dometic ventilation grilles to ensure safe
operation.
No. in
fig. a, page 9
Description
1 Installation frame
2 Ventilation grille
3Slider
4 Winter cover for the ventilation grille (accessories)
5 Adapter for the condensation drain hose
NOTE
• Condensation can form inside the refrigerator due to frequent door
opening, incorrectly stored food or food that is stored when it is too
warm.
• Condensation must be drained with a constant slope.
To Next Page
Loading...
