22
5.12 Lower Board
P1 To upper control / display board
P2 Thermistor
P3 To gas valve and igniter
J1 Positive 12V DC from thermofuse / terminal block
J2 To interior light (switched)
J3 To climate control heating cables (switched)
To Door ignition lock
To activate 12 Volt relay to power
Water dispencer light & valve
Ice Maker water line heater
Ventilator fans
Typical RM1350M Wiring Diagram
J4 Negative lead from thermocouple
J11 To D+ treminal (TAG Line)
J12 To activate interor light for low ambient control
J6 AC neutral (White)
J7 AC heater
J5 AC Hot (Black)
J8 AC heater
J9 Positive wire from thermocouple
J10 Negative to Chassis ground at control board
NOTE: Terminals 9 and 10 could be reversed as both ter-
minals are chassis ground on control board.
To Next Page
Loading...
