RMD10 Using the refrigerator
25
6.9 Stand-alone gas operation (accessory)
!
I
For stand-alone gas mode, the optional battery packs must be installed or the
optional Ø2,5/5,5 mm connector must be plugged into a 9 Vg powerbank. This makes
connecting to AC or DC power unnecessary.
When using 12 batteries (type AA), the refrigerator can be operated in stand-alone
gas mode for 2 to 3 days.
Please note the following special features for stand-alone gas mode:
• The refrigerator interior lighting remains switched off.
• The display turns off 2 seconds after the last activity.
• The display switches on briefly every 15 seconds. This indicates that the
refrigerator is on.
• If there is a pending error message, the display switches on permanently.
Stand-alone gas mode is indicated
• RMD10.5T, RMD10.5XT: by the symbols and
• RMD10.5, RMD10.5X, RMD10.5S, RMD10.5XS: flashing of LED every
15 seconds
The batteries of the battery packs must be replaced
• RMD10.5T, RMD10.5XT: when the error “E 14” is displayed
• RMD10.5, RMD10.5X, RMD10.5S, RMD10.5XS: when the error / is
displayed
WARNING!
In stand-alone gas mode, the refrigerator must be switched off manually
during refueling.
NOTE
• When no AC or DC power is connected, there is a load on the
batteries even when the refrigerator is off.
• Remove the batteries when the refrigerator is not in use (risk of
leakage).
• If your vehicle manufacturer has installed the
Ø2,5/5,5 mm connector,
ask the manufacturer about the connection point for the 9 Vg powerbank.
RMD10-O-WEST.book Seite 25 Donnerstag, 14. Mai 2020 1:16 13
To Next Page
Loading...
