Dometic RMD 10.5 Series - Shelf Positioning and Defrosting Procedures

EN
RMD10 Using the refrigerator
29
6.15 Positioning the shelves
!
➤ Remove the shelf as shown (fig. 9, page 8).
➤ Re-assemble the shelf in the reverse order.
Positioning the shelf at an angle for wine bottles
A
➤ Change the position of the shelf as shown (fig. 0, page 8).
Removing and inserting the VG-Fresh base (only RMD10.5T, RMD10.5XT)
➤ Proceed as shown (fig. a, page 9).
6.16 Defrosting the refrigerator
A
I
➤ Proceed as shown (fig. b, page 10).
WARNING! Children beware!
All shelves are fixed in place to prevent children from climbing inside the
refrigerator.
• Only remove the shelves for cleaning purposes.
• Refit the shelves and lock them in place.
NOTICE!
While driving, the shelf in the angled position must not be filled.
NOTICE!
Do not use mechanical tools or a hair dryer to remove ice or loosen
frozen items.
NOTE
Over time, frost builds up on the cooling fins inside the refrigerator. If this
layer of frost is about 3 mm thick, you should defrost the refrigerator.
RMD10-O-WEST.book Seite 29 Donnerstag, 14. Mai 2020 1:16 13