14
4.2 Maintenance
4.3 Electrical operation
12V-voltage (on-board power supply)
The refrigerator should only be used in
12VDC-operation while the vehicle’s engi-
ne is running, otherwise the on-board-bat-
tery would be discharged within a few
hours!
CAUTION!
n The gas burner must be inspected and
cleaned as necessary at least once a
year. Keep the evidence of maintenance
work carried out on your refrigerator.
n Work on gas and electrical equipment
shall be carried out by qualified person-
nel only.
It is recommended that this is carried out by
an authorised customer services depart-
ment.
We recommend maintenance following an
extended shutdown of the vehicle. Please
contact our customer services.
Mains power (230V)
This option should only be selected where
the supply voltage of the connection for
power supply corresponds to the value
specified on the data plate. Any difference
in values may result in damage the
appliance.
CAUTION!
Refrigerator operation
4.0 Refrigerator operation
The refrigerator is equipped to operate on
three power modes:
n Mains voltage (230V AC)
n Direct-current voltage (12V DC)
n Gas (Universal LP Gas)
Select the desired power mode by the energy
selector switch (battery igniter type models)
or the energy selector button (MES, AES).
Appliances with automatic energy selection
(AES) are additionally provided with "automa-
tic mode" function. Then the AES system
automatically selects the best energy source
for each particular situation.
n When the appliance is first put into operati-
on, there may be a mild odour which will
disappear after a few hours.
n Park the vehicle level, particularly when
starting up the refrigerator and filling with
food before starting a journey.
n The cooling unit is silent in operation.
n The refrigerator will take several hours to
reach its operating temperature in the coo-
ling compartment. The freezer compart-
ment should be cold about one hour after
switching on the refrigerator.
i
4.1 Cleaning
Before starting up the refrigerator, it is recom-
mended that you clean it inside and repeat this
at regular intervals.
Use a soft cloth and lukewarm water with a
mild detergent. Then wipe out the appliance
with clean water and dry thoroughly.
Keep the condensation water drain channel
free of deposits.
To avoid material alterations, do not use soap
or hard, abrasive or soda-based cleaning
agents. Do not allow the door seal to come
into contact with oil or grease.
To Next Page
Loading...
