EasyManua.ls Logo

Dometic RMDT8505 - Failure Display and Indicators; 4.19 Information on failure display and trouble-shooting; Oven Operation - Overview; 5.1 Explanation of the oven

Dometic RMDT8505
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26
Fig. 43
Fig. 44
1 2
3
7 8
1
2 3 4
7 8
Refrigerator operation
flashing +
acoustic
signal 20 s
Check burner, burner nozzles, if necessary contact
Customer Service and arrange replacement
Burner defective or coo-
ling unit defective
7
3
Operation with on-board 12 V power supply
Indicator
Fault
Remedy
flashing +
acoustic signal
20 s
Check mains power connection, mains voltage, fuse230V mode: "230V" not
available or voltage too
low
8
2
flashing +
acoustic signal
20 s
Arrange replacement of 230V heating element,
contact Customer Service
230V mode: 230V hea-
ting element defective
7
2
flashing
contact Customer ServiceTemperature sensor
without contact or
defective
7
flashing +
acoustic signal
20 s
Arrange replacement of 12V heating element,
contact Customer Service
12V mode: 12V heating
element defective
7
4
flashing +
acoustic signal
20 s
Check 12 V connection, on-board battery, fuse
AES: Check D+ signal
12V mode: „: "12 V" not
available or voltage too
low
8
4
flashing +
acoustic signal
20 s
GAS/Automatic mode:
Flame not ignited
8
3
Check gas supply (gas bottle, gas valve)
Press the button after clearing the fault.
Acoustic signal,
15 s, at 2 minute
intervals
Interior lighting is swit-
ched on
Close door, check door contact
4.19 Information on failure display
and trouble-shooting
4.19.1 Status indicators
Before notifying the authorised Service Center,
please check whether:
n the instructions in section "Operating the
refrigerator" have been observed.
n the refrigerator stands level.
n it is possible to operate the refrigerator with
any available power source.
n Refrigerators with an electronics system
(MES, AES) indicate the occurence of a
malfunction by the LED or display flashing.
n If a malfunction occurs, the indicator LED
"Failure" (8) flashes simultaneously. In the
case of AES models an acoustic alarm
sounds.
= Button ON / OFF
= Energy selector switch 230 V AC
= Energy selector switch GAS
= Energy selector switch 12V DC
2
1
3
4
= temperature level display
= fault LED / GAS FAULT reset button
8
7
289 0317-40_EN_RMDT8xxx-Bedienung_N2-2_Layout 1 26.04.2013 13:56 Seite 26

Table of Contents

Other manuals for Dometic RMDT8505

Related product manuals