RML9330 – RML9435 Safety instructions
15
Never use a naked flame to check the refrigerator for leaks.
This refrigerator may only be repaired by qualified personnel.
Inadequate repairs may cause serious hazards.
Only use propane or butane gas (not natural gas).
Only operate the refrigerator at the pressure shown on the type
plate. Use a DIN-DVGW-approved pressure regulator with a
fixed setting in accordance with DIN EN 12864.
Dismantle all refrigerator doors for the disposal of the old
refrigerator and leave the shelves in the refrigerator to prevent
accidental enclosure and suffocation.
!
CAUTION!
Danger of crushing! Do not put your fingers into the hinge.
Before starting the device, ensure that the power supply line
and the plug are dry.
A
NOTICE!
Only hold the refrigerator at the body of the refrigerator during
transport. Never hold the refrigerator at the absorber unit, the
cooling fins, the gas pipes, the door or the control panel.
Make sure that the refrigerator circuit is not damaged during
transportation. The refrigerant in the refrigerator circuit is highly
flammable.
In the event of any damage to the refrigerator circuit:
– Avoid naked flames and sparks.
– Air the room well.
Do not install the refrigerator near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
Danger of overheating!
Always ensure sufficient ventilation so that the heat generated
during operation can dissipate. Make sure that the refrigerator
is sufficiently far away from walls and other objects so that the
air can circulate.
Check that the voltage specification on the type plate is the
same as that of the power supply.
Do not open the refrigerant circuit under any circumstances.
Only use the AC connection cable supplied to connect the
refrigerator to the AC mains.
Only use cables with a suitable size.
To Next Page
Loading...
Need help?
General
