RM(x)8xx6 Using the refrigerator
29
Operating with DC power supply
A
I
➤ Select .
Gas operation
!
A
I
➤ Select .
NOTICE!
Observe the safety instructions in chapter “Safety when operating with
DC power” on page 20.
NOTE
• Only select operation with DC power supply (battery mode) if the
vehicle engine is running and providing sufficient voltage to the light
system, or if you are using a battery monitor.
• The cooling capacity of the refrigerator in DC operation is slightly
reduced. Operate the refrigerator with AC power supply or gas until
the desired cooling temperature is reached; only then switch to
operation with DC power supply.
WARNING!
•
Observe the safety instructions in chapter “Safety when operating
with gas” on page 20.
•
Turn off the refrigerator or set it to a different operating mode, if
refueling lasts longer than 15 minutes.
NOTICE!
Do not attach the top winter cover (not in scope of delivery) while oper-
ating with gas. This prevents heat from building up and the fumes from
the refrigerator can be extracted properly.
NOTE
• When operating with LPG, the burner must be cleaned frequently
(two or three times a year).
• Ignition problems may occur at altitudes above 1,000 m. If possible,
switch to a different energy source.
•
When the engine is stopped the gas is blocked for 15 minutes and
the LED lights up.
RM(X)8xx6-O-EN-DE.book Seite 29 Dienstag, 12. Juni 2018 9:01 09
To Next Page
Loading...
