Dometic SKE 180 - Retrofitting Electrical Door Control - RH 355;356; Mounting Electrical Door Control - Underside

INSTRUCTION
Retrofit Elelectrical Door Control
RH 355, RH 356
In order to retrofit the electrical door control for the above model, the following service-kit
with spare part number 210 6821-30 will be required.
You can order the service-kit at:
Electrolux GmbH
Export department
In der Steinwiese 16
D- 57074 Siegen
Tel.: 0049 271/ 692-0
Fax.: 0049 271/ 629-300
Mounting the Electrical Door Control
16
Service-Kit
Spare part number:
210 6821-30
A
B
C
D
If the minibar is wellappointed with 4 feet (8mm high), replace the 4 feet with new
feet (11mm high). Spare part number 295 1182-02.
Attention! The feet are not contain in the service-kit. Order the 4 feet separately.
If the miniBar is wellappointed with feet 11mm or higher, the high for the door
control is ok.
1. Pull out the mains plug.
599 4722-62/6 RS 31.03.1999
2. Mount the sensor and the magnet.
miniBar-underside
The magnet should be
directed towards the
inside of the miniBar.
Scotch tape
Position for mouning the sen-
sor (D) with the clamp (B).
Position for mounting the magnet.