Operation CF18 – CF60
18
7.5 Using the cooler
A
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
➤ Close the cooler, see chapter “Connecting to a battery (vehicle or boat)” on
page 15.
I
CF18
➤ Set the slide switch (fig. 3 4, page 9) to “HIGH” when power is supplied by
your vehicle's starter battery.
➤ Set the slide switch (fig. 3 4, page 9) to “LOW” when power is supplied by an
external DC power supply source.
✓ The “POWER” LED is lit green.
✓ The cooler starts cooling the interior.
✓ When the cooling temperature has been reached, the “POWER” LED is lit yellow.
CF25, CF35, CF40, CF50, CF60
➤ Press the “ON/OFF” button (fig. 4 1, page 10) for between one and two
seconds.
✓ The “POWER” LED lights up.
✓ The display (fig. 4 5, page 10) switches on and shows the current temperature.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. The cooler MUST maintain a MINIMUM of 50 mm
away from walls or similar surfaces which could restrict important air flow
requirements of the cooling system.
NOTE
Place the cooler as shown (fig. 1, page 6). If you operate the box in a
different position it can be damaged.
NOTE
If you wish to operate the cooler from the AC power supply, set the
battery monitor to the “LOW” position.
CF18-CF60-O-AUS.book Seite 18 Dienstag, 17. September 2019 8:49 08
To Next Page
Loading...
