CF18 – CF60 Operation
21
7.10 Replacing the AC fuse (CF35, CF40, CF50, CF60)
D
➤ Pull off the connection cable.
➤ Pry out the fuse insert (fig. 6 2, page 11) with a screwdriver.
➤ Replace the defective fuse with a new one that has the same rating (T4AL 250 V).
➤ Press the fuse insert back into the housing.
7.11 Replacing the DC plug fuse
➤ Pull the adapter sleeve (4) off of the plug.
➤ Unscrew the screw (5) out of the upper half of the housing (1).
➤ Carefully raise the upper half of the housing from the lower (6) half.
➤ Take out the contact pin (3).
➤ Replace the defective fuse (2) with a new fuse of the same type and rating (8 A
32 V).
➤ Re-assemble the plug in the reverse order.
I
DANGER! Danger of electrocution!
Disconnect the connection cable before you replace the device fuse.
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorised repair
centre.
1 2 3
4
5
6
CF18-CF60-O-AUS.book Seite 21 Dienstag, 17. September 2019 8:49 08
To Next Page
Loading...
