Downloaded from www.vandenborre.be
DO9046C
REMOVAL AND PLACEMENT OF PLATES
Removal
• Unplug the electric lead and let the appliance
cool off completely before removing plates
• Open your Family Croque toasted sandwich
maker using the handle.
• Push the two grill plate clip-locks (6) of the
lower plate
• towards you, one after the other, to remove the
plate.
• As soon as you disconnect the second lock, the
plate
• will unclip. Push the lock of the upper plate
away
• from you to release it. Then remove the plates
from
• the appliance.
Placement
• Open the appliance.
• At the bottom of both grill plates there are
two ridges that t into the notches of the
appliance. Fit the ridges of the grill plate into
the notches.
• Push the baking plate into place with your
two thumbs and then clip to lock. The lock
will keep them in place when they are
installed correctly.
• Do the same for the second grill plate and
make sure both are properly installed by
closing your Family Croque carefully.
INSTRUCTIONS FOR USE
Before rst time use you should clean your Family Croque (see Cleaning) to remove
any possible manufacturing residues and dust.
With rst time use, a ne smoke and odour may be released.
This is perfectly normal and will not occur anymore afterwards.
We recommend not consuming the very rst food you heat in the device.
• Plug into the socket.
• Close the lid of your Family Croque.
• The red light will switch. Pre-heating will take approximately 6 minutes.
• When the correct temperature is reached, the temperature indicator will light up
green.
• During baking, this light may switch on and off to indicate the correct temperature
20
To Next Page
Loading...
Need help?
General
