Domo DO991K - Page 49

49
DO991K
www.domo-elektro.be
EN
· Avoid direct sunlight and heat. Direct sunlight may aect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the
evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A dierent voltage could damage the
appliance.
· After installation, leave the freezer for 24 hours before turning it on. This way the refrigerant can
settle.
· Allow the appliance to run empty for 8 hours so the compartment can cool to the appropriate
temperature.
· One can level the appliance using adjustable legs. The adjustable legs can be adjusting by screwing
them in or out of the appliance.
Lengthen Shorten
17
A
600
B
650
C
1
D min=50
E min=50
F
G 835
H
323
F
F
I
I 115°
10
16
· The climate class indicates the minimum and maximum ambient temperature for the proper operation
of an appliance. You can nd the climate class on the type plate on the back of the appliance.
· SN: Subnormal: ambient temperature between 10°C and 32°C
· N: Normal: ambient temperature between 16°C and 32°C
· ST: Subtropical: ambient temperature between 16°C and 38°C
· T: Tropical: ambient temperature between 16°C and 43°C
HANDLE
1. Remove the covers from the screw holes.
2. Install the handle. This can be found in the vegetable drawer.
3. Install the handle covers.