General Principles
GL-8
Protective Measures while Repairing
To assure safety in repairing, the following protective measures
should be taken all the way:
1） Before reparation, you should ensure that the wheels can not
turn. The measure to lock wheels is as the sketch map.
2） Ensure that the gearbox is at neutral position.
3） Ensure that the ignition switch is at "off" postion.
4） When repairing electric circuit, the negative pole should be
disconnected.
5） The jacks and brackets used should be strong enough for the
load acting on them.
Method of mounting brackets is as the sketch map.
The supporting points of front axle for mounting jacks is as the
sketch map.
The supporting points of rear axle for mounting jacks is as the
sketch map.
Gearbox 4.2
Rear axle Add till the oil overflow from the inspection hole
Clutch Add to the scale of "MAX" of clutch oil reservoir
Power steering gear Add between the upper and lower scale of oil tank
Volume Data
Part
Vo l u m e （L）
To Next Page
Loading...