Clutch
CL-1
Clutch
Main Parameter
Note:
The DOT4 compound brake fluid is recommended to the clutch.
Unclean or dirty brake fluid is forbidden to use.
Do not splash the brake fluid down to the paint. (It may erode the paint.)
You must make use of the tools to disassemble and assemble the clutch pipeline system.
Make use of the clean brake fluid to clean the master cylinder, booster and the fluid reservoir.
The mining oil such as gasoline, kerosene, etc., it will erode the rubber parts in the hydraulic pressure sys-
tem.
After clean the clutch pressure plate, dry it with the suction cleaner, not the compression air.
Bolt install hole size
Distributing diameter (mm)
Φ 379
Aperture (mm)
Φ 10.5 (+0.27)
Number of holes 8 (4 pairs)
Positioning pin hole size
Distributing diameter (mm)
Φ 384
Aperture (mm)
Φ 9.5 (+0.061, +0.025)
Φ 7.9 (+0.061, +0.025)
Number of holes 2
Angle between positioning hole and installing bolt hole
10°
Friction lining size D×d
Φ 325× Φ 200
Working pressure force 11300±13500
Release bearing stroke (mm) 10~11.5
Pressure plate lift range (mm)
≥ 1.5
Height of release finger (mm) 56±1.6
Unbalance static of the cover assembly (g.cm)
≤ 70
Unbalance static of the driven disc assembly (g.cm)
≤ 35
Torque (N.m) Mmax=1087
To Next Page
Loading...